Raymond mill machine Operation and switching needing attention matters

Raymond mill before starting, check all maintenance doors are closed tightly, check the broken jaw plate gap machine with feed particle size analysis, adjust the machine speed should approximate the finished product size requirements. Finally in order to boot.
1, use the bucket elevator;
2, start the jaw crusher;
3, to have the material hopper, start the analysis machine;
4, start the blower (empty load starting, to normal operation after loading);
5, start the Raymond mill host, host starts at the start of the moment of electromagnetic vibration feeder. Raymond milling grinding work is started at this time.
raymond mill operation sequence is simple as follows: Start: lifting machine, crushing machine, the analysis engine, fan, host, feeder. Raymond mill machine shut down the machine in the following sequence:
1, turn off the feeder stop feeding;
2, after about a minute to stop the host;
3, cleaning the residual particles after the cessation of blower;
4, finally closing analysis machine.
Raymond Mill shutdown sequence is: feeder, the host machine, blower, analysis. Note: the material is transported to the hopper lifting machine to a certain amount, stop the crusher first and then increase, this should be the change of storage.
Raymond Mill in normal working hours are not allowed to be filling, to ensure production safety, milling machine in any part of the occurrence of abnormal noise, or load increases suddenly, should immediately stop check, troubleshooting, so as to avoid the occurrence of major accidents. Continue to boot must be removed or mill more than expected, the boot when the current is too large, the start.